Showing 4529–4544 of 5526 results
This is a Bluetooth 5.0 MP3 Audio Decoder or Receiver Module. It consists of a Bluetooth decoder chip, micro USB, 3.5mm dual channel headphone jack, Bluetooth Antenna and LED for Indication. Features Ready to use Ultra small volume DIY Embedded Lossless Decording Version Bluetooth 5.0 Support Lithium Battery Charging Follow Instruction Configure with Bluetooth After the power…
MP3-TF-16P MP3 Disk TF Card Module Serial Port is a compact and inexpensive MP3 module that can be connected directly to the speaker. Module with battery power supply, speaker, the keypad can be used alone, or through the serial port control, as the Arduino UNO or any microcontroller with a serial port module. The module’s…
This MPR121 is a capacitive touch sensor controller driven by an I2C interface. The chip can control up to twelve individual electrodes, as well as a simulated thirteenth electrode The MPR121 also features eight LED driving pins, when these pins are not configured as electrodes, they may be used to drive LEDs. There are four…
MPU-6050 Module consists of 3 axis accelerometer and 3 axis gyrometer. MPU-6050 is used to measure motion-related parameters like velocity, acceleration, displacement, orientation, etc. There is an inbuilt 16 bit ADC in the MPU-6050 module that provides high accuracy. The module has an onboard Digital Motion Processor (DMP) capable of processing complex 9-axis motion fusion…
This is an MQ-135 Air Quality Gas Sensor. MQ135 Gas Sensor Module with Digital and Analog Output for Air Quality. The MQ135 gas sensor’s sensitive material is SnO2, which has lower conductivity in clean air. When the target combustible gas is present, the sensor conductivity increases as the gas concentration increases. The MQ135 gas sensor is…
MQ135 gas sensor module for air quality with digital and analog output. The sensitive material of the MQ135 gas sensor is SnO2, which has a lower conductivity in clean air. When the target combustible gas is present, the conductivity of the sensors increases as the concentration of the gas increases. The MQ135 gas sensor is…
This MQ-2 gas sensor is an electronic sensor that detects the concentration of gases in the air, including LPG, propane, methane, hydrogen, smoke, and carbon monoxide. It has a sensing material that changes resistance when it comes into contact with the gas. This change in resistance value is used for gas detection. MQ2 is a…
This MQ-3 Alcohol gas sensor detects the concentration of alcohol gas in the air and produces an analogue voltage reading. Breathalyzers can detect concentrations ranging from 0.04 mg/L to 4 mg/L. The sensor operates in temperatures ranging from -10 to 50°C and draws less than 150 mA at 5 V. The heater creates the necessary…
MQ-3 module can detect alcohol, benzene, CH4, hexane, LPG, and CO. The sensitive material in the MQ-3 gas sensor is SnO2, which has a reduced conductivity in clear air. When the target alcohol gas is present, the sensor’s conductivity increases in accordance with the increase in gas concentration. The MQ-3 sensor has a high sensitivity…
This MQ4 – Methane Gas sensor module can sense the presence of compressed Natural Gas sensors (CNG), methane(CH4) etc. in the air. This is a very easy to use low-cost semiconductor Gas sensor Module with analog and digital output. It requires no external components just plug in VCC & ground pins and you are ready to go….
This MQ-4 High Sensitivity Gas Methane (CNG) Detector Sensor Module detects the presence of Compressed Natural Gas (CNG), methane (CH4), and other gases in the air. It has an analog output that corresponds to the concentration of gases in the air and a simple digital output. Specification Model MQ-4 Type Gas Sensor No. of Pin…
The Sensitive Material MQ-5 gas sensor is used to clean the air in areas with low tin dioxide conductivity (sno2). When there is a combustible gas sensor in the environment, the conductivity sensor increases as the concentration of combustible gases in the air increases. It is commonly used in gas leakage detecting equipment in consumer and…
This MQ-6 LPG – Isobutane – Propane Gas Sensor is a semiconductor gas sensor that detects the presence of LPG, Isobutane, and Propane gas at concentrations ranging from 100 ppm to 10,000 ppm, allowing for the detection of gas leaks. The simple analogue voltage interface of the sensor requires only one analogue input pin from…
MQ6 Gas sensor is a Metal Oxide Semiconductor (MOS) type Gas Sensor mostly used to detect the LPG and Butane gas concentration in the air either at home or in industry. This sensor has a detecting element made primarily of ceramic with an aluminum-oxide base and a tin dioxide coating that is encased in a stainless steel mesh. Its…
This MQ7 Gas Sensor is another MQ Gas Sensors family Metal Oxide Semiconductor (MOS) type Gas Sensor. Its primary application is to detect carbon monoxide. This sensor has a sensing element that is mostly aluminium-oxide-based ceramic that has been coated with Tin dioxide (SnO2) and is enclosed in a stainless-steel mesh. When CO gas comes…
MQ-7 is used for sensing CO concentrations in the air. The MQ-7 can detect CO levels ranging from 10 to 500 parts per million. This sensor has high sensitivity and a fast response time. The output of the sensor is an analog resistance. The sensor works in temperatures ranging from -10 to 50°C and consumes…